PSPP provides independent third-party inspection (TPI) at manufacturer facilities and project sites — verifying that equipment is built, tested and released strictly to your inspection and test plan (ITP), purchase-order requirements and the applicable international codes. As an impartial party with no stake in the supply contract, our finding is a verified fact you can act on, not a supplier’s assurance.

Inspection scope

Vendor / source inspection — welding, coating, machining, assembly and E&I workmanship
Factory Acceptance Test (FAT) and Site Acceptance Test (SAT) witnessing
Pre-Shipment Inspection (PSI) with packing, marking and documentation verification
Receiving and incoming-goods inspection
Pressure-equipment, structural and rotating-equipment inspection within approved competence

Inspections are performed by competent internal personnel and our network of approved specialist inspectors, selected per discipline, certification and client requirement. We do not manufacture, design or own testing laboratories — we verify, witness and report.

Methodology

Every assignment follows our controlled inspection workflow so results are traceable and defensible:

Requirement review — scope, location, ITP, standards and hold/witness points are clarified before mobilisation
Inspector selection and competence verification against the discipline and client requirement
Pre-inspection coordination — access, safety, documentation and schedule
On-site witnessing and evidence collection at defined hold and witness points
Nonconformity handling and immediate notification where issues are found
Internal report review before release, then a documented inspection report to the client

Vendor & Source Inspection

Inspection scope

Scope of services

Methodology